- 5 – 3″ Tapered Cover
- 1.5 lb Density Cores
- Full Length Heat Seal
- 2 Vinyl Handles
- 4 Wind Tough Straps
- Extra Grommets
5 – 3″ Tapered Cover
By upgrading the core thickness in our 5 to 3” tapered cover, we also increase the core’s strength. This means your new spa cover will stand up better to normal wear, as well as light snow conditions.
The R value, which is the insulation effectiveness of the cover, also increases 15%.
1.5 lb Density Cores
The higher the core density, the stronger your cover will be, and the less likely it is to crack or break.
Our Spa Covers feature a core density of 1.5 pounds. This is standard for a new spa purchase and provides sufficient strength in a variety of climates.
Cheaper covers use 1 or 1.2 lb densities to keep their advertised cost low and then charge extra for what we include as standard on your new spa cover.
Strength Rating: 465
Insulating R Value: 17
2 Vinyl Handles
With five layers of internal reinforcing, our recessed handles are engineered for strength and good looks.
The handles are conveniently centered at the front and rear of each cover.
4 Wind Tough Straps
Our triple-reinforced, wind-tough straps are standard, (not an upgrade) on all our covers, helping to keep your cover in place under normal winter conditions.
New safety clips are also included on your cover for the same standard price.
Full Length Heat Seal
The most common places to lose heat are at either end of the cover hinge or along the hinge itself.
Most manufacturers compensate by adding a small pad at either end of the hinge; then charge more for additional protection.
Our Optimizer and Atlas covers include a full-length heat seal to prevent leak points all along the hinge, not just at the ends. This saves heat, energy and money.
Extra Drainage Grommets
Not just one drainage grommet but 2 per side.
If you’ve ever had water trapped on the underside of your cover and it has nowhere to go, you’ll understand why these extra grommets are so important.
And they are standard on all easy spa parts covers